Hi Team,
22/6 250&500 hr service done on both mains.
23/6 Oil was over full at prestarts. Notified Willie who responded with an email.
During our Drills the Anchor Winch handle became stuck in the Capstain. Maintenance removed the locking wheel from the handle.
24/6 Engine Oil levels are back to Full. No entry into Engineering log by maintenance regarding removal of oil.
26/6 port bilge alarm not working MRF 7686. Alarm sounds maybe 1/5 times.
28/6 maintenance took measurements for new fire sea strainer Stb main.
5/7 Hamilton fault codes reported MRF 7733
6/7 maintenance checked fault codes above.
8/7 maintenance replaced shore power limit switch and installed new light bracket for life ring w/house.
9/7 maintenance replaced turbos pt & Stb, along with some raw water pipes on Stb side. Also Genset service.
10/7 maintenance preformed valve sets on both mains and cleaned sea strainer for Genset. ESR 4051 sent today. New battery box strap for battery box in Genset enclosure.
Rusted through grate on GL4 boarding platform. Has been inspected by Lee Jorgensen. See photos and emails.
11/7 Port main is slowly using Coolant. Ordered scania coolant. See ESR 4052
Enjoy your swing