Vessel Forms Page
Home Page
Ferry Masters Handover Report
Date
2017-11-08
Last day of swing
Vessel Name
Brahminy Kite
Brahminy Kite
Bruce
Canaipa
Capricornian Spirit
Freedom Monarch
Goodna
James Grant
Maintenance
Minjerribah
MOT
Nancy Wake
Office
Palm Cat
Parangool
Pontoon
QC1
Quandamooka
Reef Quest
Shute Harbour
Slipway Pontoon
Sun Harmony
Sun Serenity
Sun Symphony
Torresian
Trojan
Vessel Staus
Operation. Maintainence day after morning run on the 15/11/17
Fuel
Water
Sullage
Bridge Equipment
Operational
Furuno Radar
Yes\
No\ Comments
Furuno Doppler Log
Yes\
No\ Comments
Furuno GPS\Radar\Plotter
Yes\
No\ Comments
AIS
Yes\
No\ Comments
Compass and Lt
Yes\
No\ Comments
Jet Unit Steering Control - Main
Yes\
No\ Comments
Jet Unit Steering Control - Backup
Yes\
No\ Comments
Jet Unit Bucket Controls 1, 2, 3 & 4
Yes\
No\ Comments
Search Light\Fleur System
Yes\
No\ Comments
MRF to be repaired
CCTV System
Yes\
No\ Comments
Air conditioner wheelhouse
Yes\
No\ Comments
Window wipers Fwd
Yes\
No\ Comments
EPIRB
Yes\
No\ Comments
Nav Lights
Yes\
No\ Comments
VHF Radio x2 (Fwd and Aft console)
Yes\
No\ Comments
UHF Hand held sets x5
Yes\
No\ Comments
Bildge Alarms
Yes\
No\ Comments
Fire system
Yes\
No\ Comments
Public Address System
Yes\
No\ Comments
Furuno Depth Sounder
Yes\
No\ Comments
CCTV Hull Cameras
Yes\
No\ Comments
Navigation charts
Yes\
No\ Comments
Updated to edition 22
Intercom System
Yes\
No\ Comments
First Aid Kit
Yes\
No\ Comments
Flare kit and grab bag
Yes\
No\ Comments
New flares
Wheelhouse Binoculars
Yes\
No\ Comments
Engineering
Operational
Main Engine 1
Yes\
No\ Comments
Main Engine 2
Yes\
No\ Comments
Main Engine 3
Yes\
No\ Comments
Main Engine 4
Yes\
No\ Comments
Generator 1
Yes\
No\ Comments
Generator 2
Yes\
No\ Comments
Bridge Deck and Life Saving Equipment
Operational
Rescue Tender anfd Davit
Yes\
No\ Comments
Life Rafts and Carly float
Yes\
No\ Comments
Life Rings and Smoke Lights
Yes\
No\ Comments
General Deck Equipment
Operational
Air Conditioning - Fwd Main Deck Cabin
Yes\
No\ Comments
Air Conditioning - Aft Main Deck Cabin
Yes\
No\ Comments
Air Conditioning - Upper Deck
Yes\
No\ Comments
Gas Detector
Yes\
No\ Comments
Back from repair
Refridgerator - Wheel house
Yes\
No\ Comments
Microwave Wheel house
Yes\
No\ Comments
General Comments
Please enter the Memo Content
<p>Maintenance day after morning run 15/11/17 </p> <p>-Sullage gauge repaired reads correct. </p> <p>-Charts up to date up to editions 22. Updated local NTM in iPad folder</p> <p>-Genset kept shutting down (4 times in one morning) with the same problem we have had for months (low oil pressure) this has been proven to not be low oil pressure, but an electrical issue, there is NO AUTOMATIC SHUTDOWN!!!! Sean installed a diode which will stop the Genset from automatically shutting down which is good, but also bad because if the Genset actually has low oil or an oil pressure problem it won't shut down and will cause major damage to the Genset.. Be very sure to consistently check the oil level and visually check the Genset for oil leaks until Maintainence gets a chance to fix it properly. </p> <p>-Vessel Antifouled.</p> <p>-Gas detector back on board.</p> <p>-Flares updated </p> <p>-Can depart on demand from CP 1 with supervisor name and security go clearence. </p> <p>-3 monthly due 30/11/17</p> <p>-oil leak port main behind turbo, MRF submitted, Maintainence have acknowledged it but continue to monitor.</p> <p>-Genset serviced 28/10/17, Genset strainer cleaned.</p> <p>-Conico have had a report of the ramp at CP3 sliding and therefore unsafe...!! A million people loaded and now it's an issue?! Anyway they wanted to weld a piece of 25x25mm angle to the pontoon going from the edge at 90 degrees back 750mm to stop the ramp sliding. I had concerns that this could possibly be a trip hazard for the decky stepping across as its directly where your first step across from vessel to pontoon would be. Because we don't always have the ramp across and we can step across with PFD'S then it does present as some kind of hazard, night or rain etc.. Also to grab the ramp the angle would be exposed for the first step over, once the ramp is across and pressed up to it, it would be fine. We found tieing a line from the fwd Spring bollard to the ramp did the trick... And no welding,, anyway, they also want to re paint the landing pads where the ramp goes and will do something about the sliding of the ramp!!! See email trail 9/11/17</p> <p>-Search light not swiveling or working, MRF submitted.</p> <p>-Shore power not working at CP3, tagged out waiting for Conico to repair it. Earth leakage and burnt out breaker switch panel on pontoon side, don't touch!</p> <p>Email 1/11/17 regarding emergency lights</p> <p>Flagged emails regarding extra run for you</p> <p> </p>
Name Of Person completing Hand Over
John Walker / Liam Krelle
Authorisation Code
