-removed rust from tender floor.
-added new rubber on bow ramp water seal for tender.
-complete weekly and fortnightly cleaning/maintenance lists.
-clean out Bain-Marie condensation catch.
-clean aft deck from grease overspill on crane.
-inspect tender equipment and function.
-tilt button on throttle damaged and not functioning anymore, back up tilt switches on hull and motor to be used.
-reattached freezer drawers.
-MRF submitted for tender tiller tilt control.
(Port genset blowing heaps of black exhaust)
-water blast mould on aft deck.
-tender motor serviced.
-gauge fitted to tender near seat tilt (eng hours)
-cleaned out white trim/drain of mid shops. level around stern above tender
-lettering for tender life ring stuck on.
-EPIRB on wheelhouse pt has been replaced-not registered yet, old one still registered amd is under skippers chair.
-seawater strainers all cleaned.
-Tested fire alarms
-port high lube oil temp alarm going crazy, I’ve unplugged the alarm but the L.E.D light visual alarm is still active-monitor gauges.
-radar was fine on start-up but during day lost connection to GPS interface and would not reconnect. Need to investigate exterior connections.
-bow plate (visual port for anchor chain) was lost at some point, most likely over the side so will need to get a new one made or create our own that attaches and releases quick rather then bolts.
see you in the morning :)