Welcome back,
Hope you had a good offswing.
Mains.
Stdb Aft, Oil leaks, using most oil, small pin hole leaks in Stainless Exhaust elbow, leaking some water on turbo, Have put in MRF. Flow monitor stopped working but seems to have since come good. Temps have also been sitting alot higher than the other mains, might need a barny bust, have put in a MRF.
Stbd Fwd, all good, noticed a noise coming from front of engine on cold start up the other day, might be slipping belt, hasnt happened again. Has had new Raw water pump installed.
Port Aft, all good, gearbox oil a little over full.
Port Fwd, Had an issue with it the other day not achiving full revs and vibrating. Notified maintenance, unable to find fault. The folowing day fault disapered. Shaun recons it may be an injector on the way out.
Port fuel filters were a bit cloudy, maintence said they are being changed as per MPM and to just swith over to the fresh ones.
Port Genset has been shutting down after start up, Shaun was down yesterday and cleaned the pressure sensor, was OK this morning but haven't closed the MRF just yet.
Both gensets were serviced, air filters cleaned and new anodes and impellers yesterday.
Had a fault with the light in SDBD fuel void tripping out shore power, has been rectified.
2 X 65pax life rafts are out for service.
Gas tester is up in crib room for testing
On one start ups we had control failure/power conditioner alarm on STBD FWD and PORT AFT. Has not happened again but there is a new power conditioner in the cupboard if it needs swapping out.
When bunkering be carefull as port fuel gauge will show 85% when tank is full.
Think thats about it, if Ive missed anything or you have any dramas call me on 0423 841 799.
Cheers,
Paul Schweitzer